Divine Hot Tubs Spas Topside Control Panel 4 Buttons Temp, Pump 1, Light , Pump 2 Replaced Obsolete Original

Initial Start-up

1. Priming Mode:

   • When first powered on, your spa will enter Priming Mode.
   • Repeatedly press the “Jets” button to ensure the pump is free of air.
   • Priming Mode lasts less than 5 minutes. SpaStore
   • Press “Temp” (or “Set,” “Warm,” or “Cool” on some panels) to exit.

2. Standard Mode:

   • After Priming Mode, your spa will automatically switch to Standard Mode.
   • This mode maintains your set water temperature.  SpaStore

Temperature Control (80°F - 104°F / 26°C - 40°C)

• Displaying Current Temperature:
  • The spa displays the last measured water temperature.  SpaStore
  • For accurate readings, ensure the pump has been running for at least 2 minutes.
• Setting the Temperature:
  • Single-Button Panels:
    • Press “Temp” or “Set” once to display the current set temperature.
    • Press again to start adjusting the set temperature.
    • Each press will increase or decrease the temperature.  SpaStore
    • To change direction, allow the display to revert to the current temperature, then press again.
  • Dual-Button Panels:
    • Press “Warm” or “Cool” once to display the current set temperature.
    • Press again to start adjusting the set temperature.
    • Each press of “Warm” or “Cool” will adjust the temperature accordingly.

Topside Controls

• Turning on the Pump:
  • Press the “Jets” button to turn the pump on or off.
  • To switch between low and high speeds (if equipped), press “Jets” again.
• Spa Light:
  • Press the “Light” button to turn the spa light on or off.  SpaStore
• Mode Selection (if available):
  • Press “Temp,” then “Light” to cycle through Standard, Economy, and Sleep modes.
  • Standard Mode: Maintains set temperature.
  • Economy Mode: Heats only during filter cycles.  SpaStore
  • Sleep Mode: Maintains a temperature 20°F/10°C below the set point during filter cycles.

Preset Filter Cycles

• Your spa has preset filter cycles that start automatically.  SpaStore
• The default filter time is 2 hours, but you can adjust it to 2, 4, 6, or 8 hours, or continuous filtration.
• To program: Press “Temp,” then “Jets.” Use “Temp” to adjust the filter time. Press “Jets” to exit programming.