New Version Signature Spas Topside Control Panel 4 Buttons Pump, Light, Cool, Warm Replaced Obsolete Original Exact Fit

New Version Signature Spas Topside Control Panel 4 Buttons Pump, Light, Cool, Warm Replaced Obsolete Original Exact Fit

Refilling and Starting Your Spa

1. Fill the Spa:

   • Fill the spa through the filter assembly to the correct water level.

   • Remove the water hose once filled.

2. Reassemble the Filter System:

   • Replace the filter, filter basket assembly, and filter cover securely.

3. Power On the GFCI:

   • Turn on the GFCI power supply.

   • Each time the GFCI is powered on, the spa controls will automatically run diagnostic self-checks.

   • A series of messages may appear on the topside controls during diagnostics—this is normal.

4. Priming Mode Activation:

   • After diagnostics complete, the spa will enter Priming Mode.

   • Purpose: Trapped air in the plumbing lines is safely removed to prevent damage.

   • Heater Status: Disabled during priming to avoid overheating.

   • Duration: Approximately 6 minutes (ends automatically).

5. Post-Priming Operation:

   • Once priming is complete, the primary pump will run on low speed until the preset water temperature is reached.