Current Version Strong Spas TopSide Control Panel Buttons Light Boost Mode Jet 1 Jet 2 Jet 3 Warm Cool Size 7-1/4" x 3-1/4"

Strong Spas TopSide Control Panel Size 7-1/4" x 3-1/4"
Left Side Buttons Light Boost Model Jet 1 Jet 2 Jet 3
Right Side Buttons Warm Cool

Jets 1
Press the “Jets 1” button once to turn pump 1 on or
off, and to shift between low and high speeds if
equipped. If left running, the pump will turn off after
a timeout period. The pump 1 low speed timeout on
some systems may be as long as 4 hours.
On non-circ systems, the low speed of pump 1 runs
when the blower or any other pump is on. It may
also activate for at least 1 minute every 30 minutes
to detect the spa temperature (polling) and then to
heat to the set temperature if needed, depending
upon mode.When the low speed turns on automatically, it cannot be deactivated from the panel; however, the high speed may be started.

Jets 2 (optional on some systems)
Press the “Jets 2” button once to turn pump 2 on or
off. If left running, the pump will turn off after a
timeout period.

Jets 3 (optional on some systems)
Press the “Jets 3” button once to turn pump 3 on or
off. If left running, the pump will turn off after a
timeout period.

Blower (optional on some systems)
1-speed operation: on/off; If left on, the blower will
automatically turn off after a timeout period.

Lights
Press the Light button on the topside control panel
to turn the spa light on. If your spa has perimeter
LED lights, they will also light up at the same time as
the spa light. LEDs operate in four modes.The mode
is changed by turning the light off and then immediately back on
1. Fading: The lights will cycle through all the colors
in this order:White, Cyan, Magenta, Blue,
Yellow/Green, Green, Red