Blog
How To Clean Out Your Clearwater Spas Plumbing
How To Clean Out Your Clearwater Spas Plumbing Line And Jets
1) Fill spa. Make sure the water is at least 80 degrees and all jets, diverters, and
waterfalls are in the open position.
2) SpaStore.com recommends 1 cup of bleach per 100 gallons of water = run jets for 15 minutes then let it
sit for ONLY 45 minutes. Do not let it sit more than this allotted time.
3) Follow directions on back of bottle of Jet And Line Cleaner. Do not let it sit overnight. 4) Wipe entire shell surface and re
…
Jun 27th 2024
Troubleshooting steps for an Artesian Spas pump that is not working
Troubleshooting steps for an Artesian Spas pump that is not workingClicking Near Control Board:
Possible Issue: A blown fuse on the circuit board.Action: Check the circuit board for any blown fuses and replace them if necessary.Humming But Not Turning On:
Possible Issues:Blockage in the water flow.Clogged impeller.Failed capacitor.Closed gate or valve.Actions:Inspect the water flow path for any blockages.Clean the impeller if it’s clogged.Test the capacitor or replace it if needed.Ensure all g
…
May 24th 2024
How To Replace Jacuzzi Hot Tub Spa J-300 Spa Pillow 6455-035 Rev B HYDROSOOTHE™ pillow
How to Remove and Install this 6455-035 Rev B HYDROSOOTHE™ pillow by SpaStore.com1. Remove the cabinet / skirt panel located directly behind the pillow. There will a notice about service access for the pillow.2. Carefully cut the brown paper and remove the foam until you have access to the pillow wing nuts.3. Remove the wing nuts4. Pull the pillow away from the front.5. Replace with new pillow.6. Replace the wing nuts.7. Reuse the foam and paper.8. Install cabinet / skirt panel(s)Click
…
Nov 11th 2023
Why is my Strong Spas not heating properly? How to troubleshoot and fix Strong Spas heater problems
There are a few reasons why a Strong Spas hot tub might not be heating up. Here are some of the most common causes:
Dirty filters: Dirty filters can restrict the flow of water to the heater, which can prevent it from heating up the water properly. Spa Store dot com recommends soaking your filter in chemical cleaner for 24 hours and hose off.Clogged plumbing: Clogged plumbing can also restrict the flow of water to the heater, causing the same problem.Bad heating element: The heating elemen
…
May 27th 2023
Why and How to Troubleshoot Sundance Spas Pump Not Working
There are many reasons why a hot tub pump might not be working. Here are some of the most common causes:
Airlock: An airlock is a blockage of air in the plumbing system that prevents the pump from priming. This can be caused by a number of things, such as recent drain and refill, a low water level, a faulty filter, or a kink in the hose.Clogged filter: A clogged filter can restrict the flow of water to the pump, causing it to overheat and shut down.Faulty motor: The motor in the pump can fail i
…
May 27th 2023